#14 DISPLAY AND ELECTRONICS BRACKETS – BUILDING THE BIG 3D PRINTER

A few things to take into account:

I’ll change the position of the display, the electronics are now in where what will be the back of the printer. The display needs to be in the front and out of the way so the big parts can be extracted from the side. I’m even planning on modifying the firmware so the bed lowers to the bottom at the end of the prints so the parts can be taken out from the side.

The power supply will be connected differently, I’ll add a temperature, fire and smoke cutoff system, but first I need for it to print to calibrate everything.

I’m already preparing the wiring that’ll go on the carriage to connect everything, will se what I can do for next week.

Enjoy!!

Share Post :

More Posts