https://youtu.be/gWo0Ac6vLVs When I was getting ready to install the first wires on the printer I realised that the wire runs were incredibly long for some components, basically some of the wires had to go a complete lap around the printer. And we know that with wires, the shorter the better. Analysing the situation I realised [...]
https://youtu.be/tU_U9wS6niQ (NOTIFICATIONS WERE NOT SENT SO I HAD TO REUPLOAD, SORRY!) Hi everyone, this week video is a Q and A to answer all those questions that I get all the time in the comments, I hope you like it! Thanks!
https://youtu.be/u6sko-Coj5A This week I switch to direct feed extruder configuration. I don't think that bowden was a viable solution for this size. This time I didn't have a complete plan before starting the conversion, you'll notice. Please enjoy!
https://youtu.be/TLdFKcnDnBY In this week video I install the display and electronics of the printer. The system used is the one I've used before many times. The Ramps+Mega+Full graphics controller combo is very reliable and works standalone with an SD card, which is my preferred method. Also have been told in the comments that the lack [...]
https://youtu.be/_Qrz-JbLPAU Here it is, at last, the extruder, with a bowden configuration and an E3D clone from somewhere on Ebay. I also bought the fittings and a drive gear with a smaller diameter to improve the torque on the setup. Also learned from one of the comments that adding c-clips on the fittings will help [...]
https://www.youtube.com/watch?v=JobzC0-egis That's it! Everything is fixed for now! I could not let this one go, and I know that many of you were begging for this to be fixed. I'm not sure that it was going to break, but I did not want to be wondering that forever. Enjoy!
https://www.youtube.com/watch?v=B_Og6om3vTI Many things were fixed this week, but I'm not sure that all of them are solved. We'll see. Enjoy!