WILL IT FLOAT?

https://youtu.be/QYMTvp1IiHE   Hi Everyone! Last week I could not test this thing (I'll have to start putting names to my projects) because it rained like there was no tomorrow but this week the weather has been incredible and even the sea was calm enough for the test. I did not change anything on it, it [...]

By | 2017-11-17T20:02:30+00:00 November 17th, 2017|Fail of the day, Industrial Design, Projects, Prototyping|0 Comments

#17 – DUAL THERMISTOR VOLCANO HEATER BLOCK – BUILDING THE BIG 3D PRINTER

https://youtu.be/qNE2j6jpHc8 This two thermistor setup will allow me to trust that the heater block will not go on fire when printing unattended (which is my primary goal with this printer). Next step in this part is to set up an Arduino board that will read the thermistor continuously when the extruder is unparked and cuts [...]

Fail of the day

This is the power supply of an LED lighting system in a Springfield clothes shop. It has still the cardboard box in which the PS comes when you buy it and its fixed with duct tape to the steel structure. I guess if that cardboard is fire retardant and self extinguisable.

By | 2015-11-28T12:16:56+00:00 November 28th, 2015|Fail of the day, Industrial Design, Prototyping|0 Comments